INDUSTRIAL COMPUTER SOURCE
AIO16F-P
| Card Type | Analog to digital timing converter, Digital I/O card |
| I/O Options | parallel port |
| Data Bus | 8-bit ISA |
| Card Size | Full-length |
CONNECTIONS |
|
Function |
Label |
| 37-pin connector | CN1 |
USER CONFIGURABLE SETTINGS |
||
Function |
Label |
Position |
| Sets clock for Counter 1 to 10 MHz | W5 |
Pins 1 & 2 closed |
| Sets clock for Counter 1 to 1 MHz | W5 |
Pins 2 & 3 closed |
MUTLIPLEXER CONFIGURATION |
||
Function |
Label |
Position |
| 8-channel differential input | S3 |
8CH position |
| 16-channel single-ended input | S3 |
16CH position |
RANGE SELECTION |
||
Function |
Label |
Position |
| Unipolar | S2 |
On |
| Bipolar | S2 |
Off |
GAIN SETTINGS |
|||||
Gain |
S5/3 | S5/4 | S5/5 | S5/6 | Jumper X1/2 |
0.5 |
Off | Off | Off | Off | Off |
1 |
Off | Off | Off | Off | On |
2 |
Off | Off | Off | On | On |
5 |
Off | Off | On | Off | On |
10 |
Off | On | Off | Off | On |
User |
On | Off | Off | Off | On |
DMA LEVEL |
||
Function |
Label |
Position |
| Set DMA to level 3 | S1 |
On |
| Set DMA to level 1 | S1 |
Off |
| * If only floppy drives are installed on the system, set switch to level 3 | ||
BASE I/O ADDRESS SELECTION |
||||||
Setting |
S1/1 |
S1/2 |
S1/3 |
S1/4 |
S1/5 |
S1/6 |
000h |
On |
On |
On |
On |
On |
On |
010h |
On |
On |
On |
On |
On |
Off |
030h |
On |
On |
On |
On |
Off |
Off |
100h |
On |
Off |
On |
On |
On |
On |
200h |
Off |
On |
On |
On |
On |
On |
» 300h |
Off |
Off |
On |
On |
On |
On |
380h |
Off |
Off |
Off |
On |
On |
On |
3C0h |
Off |
Off |
Off |
Off |
On |
On |
3E0h |
Off |
Off |
Off |
Off |
Off |
On |
3F0h |
Off |
Off |
Off |
Off |
Off |
Off |
Note: A total of 64 base address settings are available. The switches are a binary representation of the decimal memory addresses. S1/1 is the Most Significant Bit and switch S1/6 is the Least Significant Bit. The switches have the following decimal values: S1/1=512, S1/2=256, S1/3=128, S1/4=64, S1/5=32, S1/6=16. Turn off the switches and add the values of the switches to obtain the correct memory address. (Off=1, On=0) |
||||||
INPUT/OUTPUT CONFIGURATION |
||||
| Setting | D4 | D5 | D6 | D7 |
| Digital ports set to input | Open | Open | Open | Open |
| Digital ports set to output | Closed | Closed | Closed | Closed |